New CCC Certification Procedure introduced
According to a recent joint announcement by the SAMR (“State Administration for Market Regulation”, “国家市场监督管理总局”) and the CNCA (“Certification and Accreditation Administration of the PRC”, “中国国家认证认可监督管理委员”), two new certification procedures are available from 1 October 2018 for the following products that are within the scope of CCC Product category, i.e.:
Certification Procedure A: self-selected laboratory type test + self-declaration
Certification Procedure B: Designated laboratory type test + self declaration
for more details please see here
Certification Procedure A: self-selected laboratory type test + self-declaration:
| Product | Implementation Regulation |
| Nominal rated voltage in information technology equipment, audio and video equipment equal to or less than 5VDC, nominal rated power consumption less than 15W (or 15VA), and no rechargeable battery equipment (Class III equipment) |
CNCA-C08-01:2014 “Rules for Implementing Compulsory Product Certification Audio and Video Equipment” CNCA-C09-01:2014 “Implementation Rules for Mandatory Product Certification Information Technology Equipment” |
Certification Procedure B: Designated laboratory type test + self declaration:
| Product | Implementation Regulation |
| Low-voltage switchgear: complete power switchgear, bus trunk system (busway), distribution board, low-voltage reactive power compensation device | CNCA-C03-01:2014 “Mandatory Product Certification Implementation Rules Low Voltage Switchgear” |
| Small-power motor | CNCA-C04-01:2014 “Rules for implementation of compulsory product certification” |
|
Small AC arc welding machine
AC arc welding machine
DC arc welding machine
TIG arc welding machine
MIG/MAG arc welding machine
Submerged arc welding machine
Plasma arc cutting machine
Plasma arc welding machine
Arc welding transformer anti-electric shock device
Welding cable coupling device
Resistance welding machine
Wire feeding device
TIG welding torch
MIG/MAG welding torch
Electrode holder
|
CNCA-C06-01:2014 “Rules for Implementation of Mandatory Product Certification Welding Machine” |
| Motor – Compressor | CNCA-C07-01:2017 “Mandatory Product Certification Implementation Rules for Household and Similar Use Equipment” |
| Automotive interior parts | CNCA-C11-09:2014 “Mandatory Product Certification Implementation Rules for Automotive Interior Parts” |
| Automotive door locks and door retainers | CNCA-C11-10:2014 “Implementation Rules for Compulsory Product Certification Car Door Locks and Door Holders” |
For general information on the CCC please look through the chapter CCC procedure. If you have any questions, please use the Contact Us page.
Source: (SAMR & CNCA: No.11)
